Rgh zypher help

Status
Not open for further replies.
T

TriiKyMoDz

Full Member
Jan 15, 2012
34
0
Hey whats up guys TriiKyMoDz here im am asking for your help i have two zypher and the first one i tried to rgh, soldered everything, it was going well until it asked me for my cpu key so i connected everything to get my cpu key but when i turn on my xbox my tv just says no signal as if it wasnt connect and my coolrunner wasnt flashing green so i solder my coolrunner to my second zypher but before i did that i made sure it connected to the tv and it did but when i connected the cool runner and read the nand it all went fine until it asked me for my cpukey again and it wouldnt connect to the tv like my other console only difference was that the light on the coolrunner was flashing green help i used j runner
 
Last edited:
A

AMIT

VIP Member
Nov 30, 2011
943
68
INDIA
where is your installation pictures ???

BTW-zyphers is hard to boot , wait until you see any light on xbox power button !
 
Last edited:
C

CHnorzy

Junior Member
Feb 3, 2012
11
0
Switzerland
How fast does the green light flash on the coolrunner?

What does the power-LED do when powering the box?

Did you get bad blocks while reading the nand twice?

How did you create the ECC?

How did you write Xell to your nand?
 
Last edited:
T

TriiKyMoDz

Full Member
Jan 15, 2012
34
0
5 seconds
No i didnt get bad blocks
i clicked create ecc
And thats it my xbox just has no display on tv
 
G

GamingRepairs

Full Member
Mar 5, 2012
33
0
Its just zephyrs. The consoles are horrible never want to cooperate. Does the green light on the CR Blink? if it does you soldered it correctly. Try rerouting wires. If still dont glitch its cause its a zephyr.
 
Status
Not open for further replies.