I'll try to keep this short.
I have purchased:
jr programmer v2
nandx phat qsbs
coolrunner rev c
I have a phat falcon and currently I have the Qsbs soldered to the board and have successfully taken 4 nand dumps that are confirmed as the same.
The issue is that I have several guides with conflicting information between youtube and tutorials. When duming the nand I am told by this guide:
http://www.ixtreme.net/jtag-rgh/20078-reset-glitch-hack-guide-using-tx-coolrunner.html
Check the number in the 2BL [CB] field. The CB needs to be one of the following to use RGH1.
Zephyr: 4578, 4579
Falcon and Opus: 5771
Jasper: 6750, 6751
Mine reads 5774 therefore I am advised to use the RGH2 method. I am correct in thinking that I do not need to write xell? When writing xell the console boots but the screen is blank both with the hdmi and av cable, I have written back the original nand dump and the console is now displaying again.
Also in accordance with the previous guide after doing the nand dumps, the next thing I needed to do is to program the cool runner using a rgh2 setting in jrunner and selecting falcon for my particular case, I have done this ensuring the cool runner was set to phat and had the prog switch set.
So am I also now right in thinking i simply set the switch to norm and soldering the cool runner to the board in accordance with this guide:
http://team-xecuter.com/forums/showthread.php?t=86539
Using of course the rgh2 wiring method.
Just to sum it up, do I not need xell as many guides and tutorials seems to talk about this and the cpu key etc. Do I simply, dump the nands (done), program the cool runner (done), solder the coolrunner to rgh2 wiring specs and the job done?
I have purchased:
jr programmer v2
nandx phat qsbs
coolrunner rev c
I have a phat falcon and currently I have the Qsbs soldered to the board and have successfully taken 4 nand dumps that are confirmed as the same.
The issue is that I have several guides with conflicting information between youtube and tutorials. When duming the nand I am told by this guide:
http://www.ixtreme.net/jtag-rgh/20078-reset-glitch-hack-guide-using-tx-coolrunner.html
Check the number in the 2BL [CB] field. The CB needs to be one of the following to use RGH1.
Zephyr: 4578, 4579
Falcon and Opus: 5771
Jasper: 6750, 6751
Mine reads 5774 therefore I am advised to use the RGH2 method. I am correct in thinking that I do not need to write xell? When writing xell the console boots but the screen is blank both with the hdmi and av cable, I have written back the original nand dump and the console is now displaying again.
Also in accordance with the previous guide after doing the nand dumps, the next thing I needed to do is to program the cool runner using a rgh2 setting in jrunner and selecting falcon for my particular case, I have done this ensuring the cool runner was set to phat and had the prog switch set.
So am I also now right in thinking i simply set the switch to norm and soldering the cool runner to the board in accordance with this guide:
http://team-xecuter.com/forums/showthread.php?t=86539
Using of course the rgh2 wiring method.
Just to sum it up, do I not need xell as many guides and tutorials seems to talk about this and the cpu key etc. Do I simply, dump the nands (done), program the cool runner (done), solder the coolrunner to rgh2 wiring specs and the job done?
