RGH RGH2 Coolrunner revA

[jeremy790]

So I have a 512mb jasper, Dash 14719 and CB6753. This board has never been glitched and I would like to go ahead and glitch it with a Coolrunner RevA I have have on hand. After reading thread upon thread I know it will have to be an RGH2 but I have seen so many different install methods. The bottom line is this http://www.team-xecuter.com/forums/showthread.php?t=82702 the best method or is there a better way to go about it without a Coolrunner RevC

 

[oO Elite Oo]

Its on this site, you need few little things to get going.

 

[jeremy790]

I understand. According to the link I post I need double shielded 50ohm cable and 10ohm resistor. I just want to know if that is the best guide before I start.

 

[Coleman]

You can start with that one and just change things around after to see what works best for your console. They're all different so something might work for you that doesn't work for someone else.

 

[jeremy790]

You can start with that one and just change things around after to see what works best for your console. They're all different so something might work for you that doesn't work for someone else.

Thank you. I will report back as I Move forward.