RGH2 Falcon Reading Nand Error

[TrukfitModz]

So I just got an error saying this when i tried reading the nand from my falcon motherboard, any help? would it it be soldering issues?
http://gyazo.com/91aee9e2a6dc4cc64a2870d006cdeddc

 

[jsinger47]

Yes.

Your SPI wire soldering is likely at fault.

 

[TrukfitModz]

Update: Just fixed the power brick didnt have a good connection

 

[john mathews]

http://team-xecuter.com/forums/showthread.php?t=96474 fill out template we need pics of soldering and a pic of chip with jr log in order to help u

 

[TrukfitModz]

http://team-xecuter.com/forums/showthread.php?t=96474 fill out template we need pics of soldering and a pic of chip with jr log in order to help u

http://gyazo.com/2ec87f4093a4933a79e22fb0f15cb076
http://gyazo.com/5dd108474bb677008308105a56a553d2

 

[TrukfitModz]

I also keep getting this error and ive soldered the wire various of times which is disk structure uncorrupted
error 0x80070571

 

[john mathews]

I also keep getting this error and ive soldered the wire various of times which is disk structure uncorrupted

are u using nand x

 

[TrukfitModz]

I'm using a jr-programmer

 

[john mathews]

http://team-xecuter.com/forums/downloads.php?do=file&id=33do u have drivers installed

 

[WildCard007]

I'd trim up the exposed wires so they are much shorter. You don't want much of the wire exposed.

 

[jdoe91011]

Trim up the wires and resolder. Once you've soldered the wires back in, get your mulitmeter out and measure that you have continuity from the corresponding header points on the BOTTOM of the motherboard to the top of your solder juncture, or if there is a little wire still exposed between the solder point and the wire insulation, you can check there. If you have continuity in this scenario, then you know you have a good connection.This is what I do with everything; I prefer to know things are going to work as opposed to hoping they are going to work.

Your multimeter is your best friend.

 

[Acton1]

if you still get an error try to read your nand and you have done all the above try reflowing the SB chip as this can cause problems with nand read