RGH RGH2 jasper 256 struggling to boot xell

[XL3THAL VIP3RX]

im having problems booting xell,ive uploaded pics of wirering.
ive got it to boot xell twice in a hour,with timeing file D..ive built my image wich is on usb stick ready,but now i carnt get bk into xell.ive done evrything in ubers guide to the dot and its taking the piss,i got it to boot first time by just wiggling the F wire wile the CR is blinking,but it wont do it now..
some imput will be greatly appresiated:smile:

 

[Martin C]

Confirm your console is still ok by flashing the first 50 blocks back (nandpro usb: -w16 nanddump1.bin 0 50) and set the CR back to PRG.

If it's ok, try what I did with a Falcon to increase boot times:

http://www.team-xecuter.com/forums/showthread.php?t=86699&page=3

 

[XL3THAL VIP3RX]

Confirm your console is still ok by flashing the first 50 blocks back (nandpro usb: -w16 nanddump1.bin 0 50) and set the CR back to PRG.

If it's ok, try what I did with a Falcon to increase boot times:

http://www.team-xecuter.com/forums/showthread.php?t=86699&page=3

consoles fine martin,i wrote the glitch image with the nandx and booted it n left it,it booted to dash but took a good few minutes to boot.
think its just a matter of settin adjustments and tweaks.
its seems to be the D file that it likes as the other ones have not worked:frown:

would you say my solderings ok?i watched those vids you posted in the rar file and took note of how you did it:smile:

 

[Martin C]

Soldering looks ok from what I can see. Try swapping out the shielded cable for the stock CPU_RST wire.