RGH RGH2 Xenon isn't creating ECC in Jrunner

[clr1121]

I read the nand, then try to create ECC and all it says is "Xenon manually selected". When I press "Write Nand" it says I don't have a ECC image.

I have soldered over my current solder and it is good.

Here is the log:



Checking Files
Finished Checking Files
Checking Console..
Version: 10
Flash Config: 0x01198010
01198010
Xenon, Zephyr, Opus, Falcon
CB Version: 1942
Xenon
Version: 10
Flash Config: 0x01198010
01198010
Xenon, Zephyr, Opus, Falcon
CB Version: 1942
Xenon
Reading Nand to C:\Users\Chris\Desktop\J-Runner v3 (5) Core Pack\output\nanddump1.bin
Reading Nand
Error: 204 reading block 146
Error: 204 reading block 14B
Error: 250 reading block 18A
Done!
in 3:26 min:sec


Initializing nanddump1.bin..
Reading Nand to C:\Users\Chris\Desktop\J-Runner v3 (5) Core Pack\output\nanddump2.bin
Xenon
Nand Initialization Finished
Reading Nand
Error: 204 reading block 146
Error: 204 reading block 14B
Error: 250 reading block 18A
Done!
in 3:26 min:sec


Comparing...
Bad Block ID 018A Found @ 0x03FF [Offset: 0x107BE00]
Block ID 03FF [Offset: 0x107BE00] remapped to Block ID 018A [Offset: 0x659400]
Bad Blocks Remapped
Bad Block ID 018A Found @ 0x03FF [Offset: 0x107BE00]
Block ID 03FF [Offset: 0x107BE00] remapped to Block ID 018A [Offset: 0x659400]
Bad Blocks Remapped
Nands are the same
Xenon Manually Selected
You need an .ecc image

 

[GeekHeat]

U can't rgh2 a xenon.

 

[joshypoo]

if its a Canada CPU then you can do RGH 1.2
twain will be CPU key recovery only.

that is all i can tell you since this is a TX site but go here

http://teamx360.co.uk/showthread.php?3150-Rgh-1-2