rjtag and cr4xl help

[john mathews]

as youll see in the pic i lifted a trace so the blue wire is a repair.View attachment 32401

this is a problem

 

[xupd39baw]

ok i thought by scrapping back and exposing the trace and running a wire from the solder point to the trace i would be fine. what solution should i try?

 

[xupd39baw]

f**k [email protected]@@@ got it!!!! thank you so much!

 

[john mathews]

f**k [email protected]@@@ got it!!!! thank you so much!

watching wwe / what did u do to get it

 

[xupd39baw]

finally got it to boot into xell.

 

[john mathews]

good job /what did u try and do

 

[xupd39baw]

on the bottom qsb i read somewhere that there was no need to solder that point right below the r where it says rjtag. when ahead and it booted instantly

 

[john mathews]

on the bottom qsb i read somewhere that there was no need to solder that point right below the r where it says rjtag. when ahead and it booted instantly

lets us know how that falcon boots

 

[briggs01]

lets us know how that falcon boots

correct me if I an wrong john but even if that spot was soldered below the r he mentioned surely it would not make it go to red lights , sound more like something shorting out to me

 

[john mathews]

correct me if I an wrong john but even if that spot was soldered below the r he mentioned surely it would not make it go to red lights , sound more like something shorting out to me

he didn't have the fan plug up/ now that he pluged it up and laid it on the heat sink all is good , that's y he was getting 2 red lights overheating