RJTAG Installation Problems, Jasper, Template inside

[granyte]

Console Type:Jasper
NAND size: 16
Dashboard version: 2.0.16537
CB version: 6754
Screenshot of NAND details from J-Runner:

POST output from J-Runner (either POST_OUT monitor or RATER output):
Nandx only..

Description of problem:
After writing Xell-reloaded the console doesn't boot. RJTAG chip shows red light and green light flashes. Green light flashes several times. The console then displays error 0022, and the flashing stops. The console works fine if flashed back to stock and the chip is removed.

Was the console working before you started:
Yes

 

[chronic1553]

you have aud_clamp selected on the jtag qsb, but you do not have the wire soldered from the qsb to the board.

 

[granyte]

Sorry, this is the first time I've used a jtag qsb. How do I deselect aud_clamp?

 

[chronic1553]

Ok in jrunner what did you select? post your jrunner log.

 

[granyte]

I've closed it already sorry. I just picked rjtag, nothing else. Audclamp option off because I wasn't using it.

It wrote fine, everything went smoothly on the jrunner end.

 

[granyte]

I think I must've broken something because now the console isn't booting even with stock nand

 

[chronic1553]

Did you remove anything?

 

[granyte]

No not at all. I'm going to flash it back to stock and unsolder the chip. I'll let you know if it boots.

 

[granyte]

It's broken.

/thread

 

[BL4K3Y]

Why don't you post a request in the correct section and see if someone local will take a look at the console for you?

If you are in the UK, I will take a look at it for you and if I can't fix it, you just pay me for postage.

 

[gavin_darkglide]

I am just curious if anyone reads the installation guides any more or if they just look at the picture, and then when it doesn't work come and post on the forums because they can't follow directions.

 

[nofeloniesyet]

It's broken.

/thread

if in usa id be happy to take a look at this for you.