RJTAG QUESTION

obie trice · Dec 14, 2013

HI JUST WANTED TO KNOW WHEN FINISH WITH RJTAG INSTALL WHAT GETS LEFT IN THE XBOX LIKE JR PROGRAMMER
DO YOU REMOVE IT

jordyne · Dec 14, 2013

obie trice · Dec 14, 2013

Thank you for the info the other thing is what is the best method to keep everything in place inside xbox after setup is complete.

BL4K3Y · Dec 14, 2013

obie trice said:
Thank you for the info the other thing is what is the best method to keep everything in place inside xbox after setup is complete.

You can keep everything installed, but remove the JRP.

If you want easy access to read/write to the NAND, buy one of these.

jordyne · Dec 14, 2013

I use a little electrical tape and hot glue but that's me:tongue:

obie trice · Dec 14, 2013

ok i will use glue gun thank for everything

jordyne · Dec 14, 2013

your welcome and goodluck

TX_F1ERCE_TX · Dec 14, 2013

Paste the R-JTAG on top of the DVD drive, and that's really it.

Vanis101 · Dec 14, 2013

TX_F1ERCE_TX said:
Paste the R-JTAG on top of the DVD drive, and that's really it.

I recently replaced the DVD drive in an R-Jtag console. Wish i had never stuck the chip to the DVD drive.

scott1503 · Dec 14, 2013

Vanis101 said:
I recently replaced the DVD drive in an R-Jtag console. Wish i had never stuck the chip to the DVD drive.

Try using zippo lighter fluid or some rubbing alcohol and it will loosen the sticky pad