RJTAG randomly freezes on logo

[h1p3rcub3]

Hi,

Thanks in advance for your help. I got a Jasper with infinite loop with RGH2, so i changed to RJTAG. The installation was good. The glitching is good (7 out of 10), but when it glitches and the Xbox 360 logo apears sometimes it loads FSD (it takes more than a minute) and sometimes it wont load at all.

When the logo appears it stil moves (the ligths in the X moves)

Can it be a hard drive problem? I use the 360 Elite HD (120Gb) in his socket?

Any ideas?

Thanks!

 

[GeekHeat]

Does it still freeze wen the HDD is not connected.

 

[Slayertex6]

Sounds like you got interference. Check your soldering points and wire placement. And yes sometimes it can be the hdd.

 

[h1p3rcub3]

Does it still freeze wen the HDD is not connected.

When i disconnect the HD it loads the original dash in a few seconds (about 5 secs)

 

[skillet34]

Sounds like the next step is try another hdd.

 

[h1p3rcub3]

When i disconnect the HD it loads the original dash in a few seconds (about 5 secs)

I have given you a bad information. When i disconnect the hard drive i happens the same. I just tried one time and (oh, my luck) it started fast. I will be checking for bad soldering and interference to see if i cand find anything.

Thanks!

 

[h1p3rcub3]

Sounds like you got interference. Check your soldering points and wire placement. And yes sometimes it can be the hdd.

I dissembled the console, and without the plastic case, the console gliched 10 over 10, and started FSD allways in a few secs. Is it possible the case may be causing some interference? Any advice?

 

[jeeboy]

Change Power mode in SMC config editor. If you have 8280 change it to 8080 or 8180 usually this is the cause.
Ive hade several ones that frooze during boot at the 360 logo.
Changing Power mode to 8080 solved it every time.
There are several threads about this.
Search the forum.