ANSWERED ROL pad of CR4 XL

[MTWallet]

Is there a concise pinout for the pads on the CR4 XL? If so, please point me there and I will be happy to read for myself, but I have searched pretty hard and other than the tutorials which just say connect this pad to this point, I couldn't find anything saying pad E does this or pad C does that.

Specific reason for asking is (although I would like to have more info about pinouts in general), I want to use the error light on my slim to show the glitch cycle. Does the ROL pad on a CR4 XL signal ground or VCC? I know I will have to find if I have a 1409 or 1410 RF board, as that will determine common ground or positive.

Also, is there a diode to prevent backfeed on the CR4 XL? Or just a resistor? Or neither?

Thanks!

 

[stucknvegas]

There is just a resistor( find if I have a 1409 or 1410 RF board) just follow the guide it works

 

[MTWallet]

...just follow the guide it works

This one? http://team-xecuter.com/forums/showthread.php?84252-Coolrunner-LED-Mod

Or this one? http://team-xecuter.com/forums/showthread.php?98481-CR-Glitch-LED-Mod-for-ALL-Versions!!

Or ???

Thanks

 

[stucknvegas]

http://team-xecuter.com/forums/showthread.php?139025-CR3-Pro-ROL-MOD

this one

 

[MTWallet]

Thanks a million for that, in all my searching I never came across that thread. I guess it doesn't show up in the forum search because rol and mod are only 3 letters and too short to search for?

Anyway, thanks again!

Answered

 

[stucknvegas]

Yea I just fumbled on it one day-- A lot of use other methods using a brighter LED
I am older and need bright lights Especially counting the glitch cycles over and over with no Rater Access