RRoD 0022 with original dash, no green light on CR (or flashes once, very quickly)

SOloNon

SOloNon

Full Member
Oct 2, 2011
62
0
GODZYLLA said:
I thought I lifted PLL point, but since I can get a solid reading betwen pll and the one under the heatsink (even scraped the trace a bit just to be sure) I think it's fine.

With the solder bridge "disabled" (or so I think it is) I can't get a reading between point 3 and point 1 (the resistor may be lifted at point 2?), between 3 and 5 I get 3ko, and between 3 and 4 10ko, so it's same as above.

Does it matter if points 1 and 2 are brigded, because from what I read they're in series?
Click to expand...
I have this question too
 
I

ishockin

VIP Member
Feb 4, 2011
275
23
Ohio
this just happened to me my jasper was glitching fine, then i wanted to put it in a different console but before i did that, i wrote back the original nand and put the coolrunner to PRG so it would be off, and now its 0022 and now im stuck cuz when i wrote back glitched image it still goes to 0022 and coolrunner wont blink
 
R

richaj06

Full Member
Aug 4, 2010
30
6
i got my first 0022 board last night could not get it to work then today put the same dam chip in a different board and the same thing happen 0022 now what the he** is going on i think that maybe some of TX coolrunner might be bad i done about 60 unit never had a issuse with one of them and now this one chip has done in 2 different boards both now have 0022 i going to be sending this chip back maybe some one will look and see what wrong with it
 
J

JohnsonMighty

VIP Member
Feb 27, 2010
195
0
richaj06 said:
i got my first 0022 board last night could not get it to work then today put the same dam chip in a different board and the same thing happen 0022 now what the he** is going on i think that maybe some of TX coolrunner might be bad i done about 60 unit never had a issuse with one of them and now this one chip has done in 2 different boards both now have 0022 i going to be sending this chip back maybe some one will look and see what wrong with it
Click to expand...
It's not a problem with the coolrunner, I used the same CR in a different board(Falcon) and worked fine, I have a feeling it's the bigger resistor that is above the green soldering point. CBA to replace it at the moment though.
 
Last edited:
L

locomoco

Noob Account
Dec 16, 2011
3
0
I had the same problem with my 16mb Jasper booting orig nand get 0022, first it turn out broken/lifted trace/pad in PLL got it fixed, still get 0022 error with wires installed so I removed all wire and solved.

Putting all wires again now I'm able to boot orig nand with CoolRunner switch to "Slim" I get 0022 if switched to "Phat". I also get 0022 if I disconnect the CR ground wire.

So what is the Phat/Slim switch do? What resistance it added to the circuit? I would like to solved this issue bcoz I'm doing dual nand on this setup.
 
Last edited:
You must log in or register to reply here.