RROD after 30sec

[cypress_hill]

i have jasper 512mb

after booting into xell and flash using the usb stick i got alot of errors(error processing block) the system shut down and the power supply turned into red then after starting the system again i got only black screen then tried to flash to original now i am stuck with RROD 0022 about 30 sec from start up do i need to reflow the GPU or what??

hint (i didn't use the fans during flashing with xell it took me about 10 min to flash)


also tried this stuff

1) removed all CR wires
2) add thermal paste to the GPU

 

[BL4K3Y]

i didn't use the fans during flashing with xell it took me about 10 min to flash

This was a bad idea :facepalm:!

The CPU and/or GPU will most likely need a reflow.

 

[cypress_hill]

so can i use air gun to do this?

 

[SniperXx]

Im surprised it didn't shut down due to overheating before the 10min mark. But yeah that probably messed something up.

 

[mechgamer123]

did it get done flashing before it overheated? One overheat isn't going to kill the xbox, especially if it's a jasper. Just try reflashing xell. This time when you have the console on though, have the fan laying over the heatsinks so it won't overheat

 

[cypress_hill]

did it get done flashing before it overheated? One overheat isn't going to kill the xbox, especially if it's a jasper. Just try reflashing xell. This time when you have the console on though, have the fan laying over the heatsinks so it won't overheat

tried that but didn't work also tried to flash the hacked image with hardware method(lpt) i got black screen and the middle green led and nothing else

also now when i start the console 2 or 3 min i can feel the GPU getting hotter is there any hope other than reflow?

 

[lonix]

I'd check pll bypass under cpu

 

[cypress_hill]

I'd check pll bypass under cpu

i think pll bypass problem give rrod 0022 after 5-10 sec from starting the console as martin c said in his article