RROD after RGH

[weegaza2k9]

Hi there this was my first attempt of an RGH. And was done on a Falcon motherboard. Now after the installation the console was unable to power up and I was presented with the RROD secondary error code 0022 which is said to be a bridged/cold joint. Now you can see from the pictures that around the HANA chip I kinda failed and it looks bridged to you think that is the problem? Any help would be appreciated thanks.

Picture of HANA Chip:
http://i41.tinypic.com/ixutfo.jpg

Picture of QSB:
http://i42.tinypic.com/mka34.jpg

 

[axee44]

Looking at your picture your qsb is too far back bridging C3B2 and R4B24

 

[weegaza2k9]

Looking at your picture your qsb is too far back bridging C3B2 and R4B24

Ah so the point under the QSB is being bridged?

That would explain why the Coolrunner is not blinking and is just a constant green light.

 

[axee44]

Tidy that up and take it from there. Just make sure you know what you are doing as qsb can be pain to remove.

 

[weegaza2k9]

Tidy that up and take it from there. Just make sure you know what you are doing as qsb can be pain to remove.

Right no problem ill try and tidy it up, all the other points are fine and I have read my NAND four times perfect.