I have the Coolrunner installed in one of my boxes and when I had the qsb's and wires soldered in, without the coolrunner hooked up, it booted fine. But now, when I have the wires soldered to the un-programmed coolrunner it RROD's. I did not drop any solder on the board or do any soldering on the board since it booted fine, so I figure it is just because the coolrunner is not programmed. Am I correct? (I also assume this as it just flashes 3 lights and gives no secondary error code)
---------- Post added at 17:48 ---------- Previous post was at 17:44 ----------
EDIT: Does not RROD anymore, not sure why it used to...
---------- Post added at 17:48 ---------- Previous post was at 17:44 ----------
EDIT: Does not RROD anymore, not sure why it used to...
