hi, you may know me from my last serval posts, but i have made an official decision. i would like to do a R-Jtag on my Jasper 16 mb. but the only problem is that i do not have any QSB's, so i have to do a wire install. but there is another problem... i dont have 2 diodes that i would need to do it with. is there anything else i can use?
JASPER RTAG help
- Thread starter willstrz
- Start date
Taijigamer2
VIP Member
U need 2 diodes mate, they are like 10p each, just go to local electronics store. I take it u have given up on Ft6u7?
Taijigamer2
VIP Member
I don't use Skype, I try to keep all info on forum. With the postout point, I would put the wire in position and then tape it down with kapton tape or electrical tape before giving a light touch with the iron, this should guard against accidental pulling and removing of the point. This is the last option, after that u will need to solder to a via or trace. Look up wire install for jtag Aud clamp. Any issues please fill in Rjtag/Rgh template. Good luck.