Ok not a new time modder, I have put in well over 20-30 chips by now, but this is the first time i have seen this, I have a 1.4 that I am putting a 2.6ce in and after getting pin header installed, it scrolls on the flash bios screen and is blank with chip turned off, Im afraid I might have done somethin, but for the life of me I don't know what? I have searched the forum and no I have not seen anything like this listed so I am posting the topic now.
Scrolling or blank screen
- Thread starter robbdeman
- Start date
Martin C
VIP Member
You may have bridged one of the vias under the pinheader. It may be the only way you can test this is to remove the pinheader completely.
Did you test the Xbox before you started and did you use the same AV cable / TV combination?
Martin
Did you test the Xbox before you started and did you use the same AV cable / TV combination?
Martin