I just realized that I may have been dumping my nand without the yellow wire soldered on properly. It was connected properly when I did my original 2 dumps but now its not even connected and I'm still able to dump it. I did compare the new dump and it doesn't match so that's a good sign.
I figured it out, got it to stick by remelting the solder inside the hole.
Might be good for other people to make sure your connections are right because I didn't think it would even try to dump if one wire was off but it did.
I figured it out, got it to stick by remelting the solder inside the hole.
Might be good for other people to make sure your connections are right because I didn't think it would even try to dump if one wire was off but it did.
Last edited: