LITEON 0225 (Slim) 0225 MXIC (in Vendor Mode) ready for LT+ 2.0?

[Byteheart]

Disregarding the thread I started a while back, I'm hoping someone can shed some light on my situation.

I have a Slim 0225 drive with a MXIC chip. When I was trying to get the drive into vendor mode using the Intro/Device ID button during the power on/off stage, I was using that protruding spring-action button on the power cable connecting my drive to the CK3 Pro, this didn't work. After thinking for a bit, I tried using the power switch on the CK3 Pro board itself during the power cycle stage and now the drive has entered vendor mode, yay!

Now, the drive also reports SPI status 0x00:

From what I can tell, this means I can now erase my drive and write my LT+ firmware? Any help would be most appreciated.

Also, just to clarify, I already have a Dummy.bin from when I first flashed the drive. Do I just take the Dummy.bin, load the appropriate LT+ 2.0 firmware, spoof to target, write the firmware, and then Outro/ATA Reset?

Thanks in advance

 

[lockpicker]

yep, dummy as source, then lt2.0 as target make sure keys match, write firmware, then lock the drive once its been written to and thats it fire it in your xbox and see if al good to go


jungleflasher should automatically select the firmware for you (lt2.0)