slim bad .Ecc image

[jaycboy]

hey i used cool shrimp tool to try get a cool runner installed on a slim done a few jaspers and falcons with the tool fine but i think its wrote a bad Ecc image as i cant turn the slim on no power what so eva cant read or write back to via nand x have tried 2 different ones i can get power sound but nothing else no fans spin etc...... I found this http://www.team-xecuter.com/forums/showthread.php?t=75072&page=2

is this the way to cure it ??? anybody else had these problems ???

 

[AudioProUK]

oh dear ...

If you can`t write to the nand. You are done for. You`ve written a bad image to the nand and now it is not powering the nand . I believe the is a way of powering the nand another way but i`ve never tried it and in MY experience these things never come out good . I would prepare yourself for a new console. sorry to sound un-hopeful but basically I am.

 

[playingmax]

did you get any bad blocks?

 

[jaycboy]

not on the first 2 dumps i made no m8y all fine compared fine... i have had problems like this before on a phat when i flashed a bad nand and had to short it out to get it to write again i just wonderd if that was the correct way to get the nand back into recovery with the link i posted the op has only a few posts so just wanted to know if anybody could confirm it works...

 

[[AD]]

Try it. The nand is simlar if not the same. So should in theory work.

-=AD=-

 

[seanr28]

hey i used cool shrimp tool to try get a cool runner installed on a slim done a few jaspers and falcons with the tool fine but i think its wrote a bad Ecc image as i cant turn the slim on no power what so eva cant read or write back to via nand x have tried 2 different ones i can get power sound but nothing else no fans spin etc...... I found this http://www.team-xecuter.com/forums/showthread.php?t=75072&page=2

is this the way to cure it ??? anybody else had these problems ???

Sounds like you may have possibly damaged the STDBY_Clk point....check carefully and ensure that the resitors next to it reads at 30 Ohms

 

[jaycboy]

thanks for the response guys i think sean28 is correct or onto the right path in the pad is damaged ill have a better look at this and get back see if i can repair it or have to send it off tbh the point is small and fragile but i have solderd to alot worse

 

[jaycboy]

Sean28 you were correct my friend it was indeed down to that point being damaged i have fixed it flashed original nand back it boots perfect will find alternate point and get this baby glitched thanks once again guys !!!

 

[jaycboy]

hi guys sorry to dregde this thread up again but its helped me in the past...anyways see if anyone can help me i have managed to RGH a slim get the key flash ecc image however on rebuilding the xbox the STDBY_Clk point wire must have been moved anyway its damaged the pad so i did the trace fix as i have done before but still same results i get it to boot once if i keep removing and resoldering although the trace repair is fine i tested it bout 20 times as i resolderd de solderd and the xbox powers on for about 10/15 secs i get the cool runner to flashes green as i have solderd alternate STDBY_Clk point to cool runner then it switches its self of i can no longer turn it after that it just does the beep thing with the front panel were you get the sound but nothing else am confused now...any recomendations

my bad shouldve googled some more the resistor is not measuring 30ohm or anywere near that so i will replace