Slim clear ghostcase

HoggFace

VIP Member
Aug 8, 2012
727
48
Bristol UK
Looks sweet mate. I'd also change the LEDs on the ROL to blue and white. That would top it off for me.


Sent from my prototype iPhone 5
 

Themonk

VIP Member
Feb 25, 2011
187
0
Was thinking of doing that mate. Done my 1 controller to clear with blue LED mod. They are extremely potchy to change though mate.
 

MANUMAN

VIP Member
Jun 11, 2011
591
0
DUBLIN
no they aint if you have the right tools and you can solder correctly they are very simple to change.

---------- Post added at 16:00 ---------- Previous post was at 15:59 ----------

if you cant do it i wil sell you a ring of light with blue leds in it if u want ?
 

pdpiech

Full Member
Jul 15, 2012
40
0
I have to get me one of those clear cases! I'd also like to make the spinning discs viewable instead of having that ugly cover on the ODD. I don't care too much for the LEDs though (except only the ones on the CoolRunner).
 

HoggFace

VIP Member
Aug 8, 2012
727
48
Bristol UK
Was thinking of doing that mate. Done my 1 controller to clear with blue LED mod. They are extremely potchy to change though mate.
I'm yet to change LEDs. I was hoping they would come in the post today.....but they didn't :-(. Hopefully tomorrow I can give it a shot.

But once again that's a bad ass case. Good job mate.


Sent from my prototype iPhone 5
 

Themonk

VIP Member
Feb 25, 2011
187
0
Got it from amazon mate. They also do a Kinnect case to match so gonna change that next.
 

HoggFace

VIP Member
Aug 8, 2012
727
48
Bristol UK
Just had a peak on their website. That kinect case looks sick!


Sent from my prototype iPhone 5
 

locobrown

VIP Member
Aug 5, 2011
322
0
no metal cage? all plastic? what are the repercussions of having the mobo mounted on that type of case.
 

Themonk

VIP Member
Feb 25, 2011
187
0
Just out of curiosity what was pain about fitting it?

Hi,

It is just a very very tight fit. Especially getting the front facia on at the end as it clips into place simular to the back.

no metal cage? all plastic? what are the repercussions of having the mobo mounted on that type of case.
The metal cage that the mobo sits in is still there. Just removed the top metal grill. However you can keep it if you want, I just prefered the look without as the blue LED's look nicer without the top section.
 

KhaineGB

VIP Member
Jun 19, 2011
727
0
Liverpool, UK
My mate got one of these, and I have to agree... it's a complete sod to fit!

Took both of us to hold the face plate and top half of the case in place while the other person slotted the bottom half into place. Looks goddamn awesome though. :)
 

DrunkenNinja

VIP Member
Oct 3, 2011
1,048
88
RGH
Is it actually called "Ghost Case"? if it is the plastic those guys use is junk, it has no flex whatsoever and will crack in the worst possible places, I can also vouch for the poor fit also, it has to be set perfectly for it to close properly, I still have one of these on my ancient Xenon (PHAT).

I later heard from other case modders that the XCM cases are the real deal, didn't try one but havn't heard anything bad about them.
 
Last edited: