CORONA Slim Corona v1 - CR4 & DemoN

Descend

Senior Member





Console Information
- Xbox 360 Slim
- Corona v1
- 250GB HDD
- Arctic Silver 5 Thermal Paste applied




I have Team Xecuter's CoolRunner 4 RGH chip installed.
The chip was installed using a double insulated cable on the CPU_RST point. This gives a pulse then a sharp charge to ground. The double shielded wire reduces interference from capacitive and inductive components thus, increasing the chances of a successful glitch/boot.

Dip switches set to default for Corona v1:
dip-corona.png





I also have Team Xecuter's DemoN chip installed.
This chip allows me to boot from two NANDs, the retail NAND on the Xbox motherboard and the DemoN's NAND on the DemoN chip.
The DemoN chip is installed with Team Xecuter's Corona QSB v2 - this is because the NAND points differ on the Corona to the ones on Trinity consoles.



The DemoN chip connects to the CoolRunner, allowing the DemoN to activate or deactivate the CoolRunner.
The DemoN chip also connects to a switch board which is mounted on the back of the console. This board allows for NAND switching and the mini-USB port allows for NAND read/write from J-Runner.



Along with the board on the back to switch NANDs, the console's sync buttons is configured to control the NAND switching with a long press while, a short press of the sync button serves its original purpose to sync the controller.


To top it all off, the console's Ring Of Light (ROL) has a blue glitch LED to show that the CoolRunner 4 has been deactivated when booting from the Retail NAND and, to show how many glitches the CoolRunner 4 takes to boot when booting from the DemoN NAND.



Thank you for visiting my topic. Please let me know what you think of my RGH setup.
-Descend
 
Last edited:
  • Like
Reactions: ablegepu

ablegepu

VIP Member
Jan 3, 2014
929
0
Alabama U.S
Nice clean install and great soldering, but that double shielded cpu_rst cable is overkill. If You personally get better boot times using it though I say why not, but the goal is said to make the wires as short as possible so I really don't see any reason in using one on slims.
Great job BTW!!
 
  • Like
Reactions: Descend

Descend

Senior Member
Nice clean install and great soldering, but that double shielded cpu_rst cable is overkill. If You personally get better boot times using it though I say why not, but the goal is said to make the wires as short as possible so I really don't see any reason in using one on slims.
Great job BTW!!
Thank you very much.
As for the ds cpu_rst: I had one lying around and, as a few people had recommended it, I thought that I might as well.
 
Last edited: