Slim Demon to Big Block Jasper?

ImJtagModz

Noob Account
Aug 18, 2013
9
1
Hi,

I have a slim demon laying round and was wondering if i can do a wire install into a big block jasper.

If i use a 10k ohm resistor between points D0 and D1 to X1 and X2 would that work?

So far i have tried this but the xbox doesnt boot with that nand.

Thanks
 

gavin_darkglide

VIP Member
Dec 14, 2012
2,311
118
Update the demon firmware to 1.4, if I remember correctly. You also have to make the nand for a small block jasper. The demon hardware is the same on both versions, just different board layouts.
 

ImJtagModz

Noob Account
Aug 18, 2013
9
1
Update the demon firmware to 1.4, if I remember correctly. You also have to make the nand for a small block jasper. The demon hardware is the same on both versions, just different board layouts.
I have updated to 1.4 but was wondering if the firmware is different because it detects it as a slim demon.

It doesnt want to power up with the demon nand. Only the Retail side
 

Support Our Sponsors