hey got problems with a slim ive got it to glitch once i booted to xell took a picture anyways after that it wouldnt boot to xell again so i resolderd wires tried again no go..so changed coolrunner thinking that could be it. then no boot at all..desolderd everything it does not boot or respond to power no beep nothing i am thinking solder splash but the power pack does not turn red and altho it does not power on the chip at the side of where i installed the coolrunner gets mighty hot so i have to unplug it....what you guys think ???? i cant see any obvious splashes this is my 20 something slim ive glitched and it did boot and i got green light on cr the problems started soon as i changed it now no boot and chips heat up :facepalm:
GENERAL slim no power
- Thread starter jaycboy
- Start date
I will post pictures in the morning of desolder/points been nowere the stndby_clk ive repaired quite a few of those those 
the point ive used is the alterante point will post piks asap thanks for all help looking for suggestions
---------- Post added at 19:31 ---------- Previous post was at 19:29 ----------
It should just blink now but it does not boot at all no beep nothing all i did was swap th cr unit after getting it to boot to xell once
the point ive used is the alterante point will post piks asap thanks for all help looking for suggestions ---------- Post added at 19:31 ---------- Previous post was at 19:29 ----------
It should just blink now but it does not boot at all no beep nothing all i did was swap th cr unit after getting it to boot to xell once
Hey guys i washed the board with iso and left it over nite booted 1st thing 1st time so i have no idea must have been a bit of solder splash.... its glitched and sorted thank you all who commented
trippy86
VIP Member
most likely a briged point somewhere, glad you sorted it but for your own good and for more efficient support in the future i would suggest you post pics at the start of your thread. makes helping much easier