RGH Slim power off after some seconds

[genio123]

Hi guys i've a problem with a slim and the RGH:
Done the RGH with the coolrunner (it's not my first one) but i've never had this problem:
flashed the ecc and it was working (booting xell fine), then i powered the console off and back on:
green light on ROL as it should be, and then (after few seconds) the console shut down itself... the fan stop working and the green light turns off.
BTW the coolrunner is working fine (red light for the power and blinking green light untill it glitches, but it dont have the time to glitch because the console shuts after the first attempt).

I've checked everything and my solders are ok...
What it can be?
Which wires are responsible for this kind of thing?

 

[sick360mods]

Post pics of soldering

sent from HTC EVO sick360mods.com

 

[genio123]

I've tried everything: even changing the swith to PHAT or taking alternative 3.3 point: no matter what, it still dont stay on when i power it.

PICS:

 

[garageinc]

you have your yellow wire hooked directly under one of the coils. could be that. i had a slim would red light if the wire was there. it also powered itself up and down during reading which was fun.

 

[BL4K3Y]

Your 3.3v wire doesn't look to be in the right place, move it across to the pad next to the one it is currently soldered too .

 

[garageinc]

your right blakey but its no where near the correct point, it should be on the pad behind the brown wire (closest side to the hana chip)

 

[genio123]

i know, that point is for ever_3.3... the one i use power on the coolrunner when i power on the console.... btw no problem: im switching it back to the original point

 

[BL4K3Y]

According to the CoolRunner install image, it should be soldered to the pad directly above I2C_SDA (brown wire) like so:

 

[genio123]

According to the CoolRunner install image, it should be soldered to the pad directly above I2C_SDA (brown wire) like so:

Link To Image

Im switching back to it

 

[genio123]

Sooooo! Here's updates on the situation, i rerouted the yellow wire away from the damned coil (i didnt see that :facepalm: ) and now it stays on!
For the happiness of blakey i also switched back to the original 3.3v point and it works

I'm leaving it on for some minutes to be sure it doesnt freeze

EDIT: IT WORKS!! Thanks guys!!!!!! It was the yellow wire

Who should i marry ?! xD

 

[BL4K3Y]

Problem solved.

Closed!