slim proto no glitch

C

cod3mwf

Full Member
Dec 16, 2013
36
0
I just installed my slim proto and my J r runner readed 2 nand dumps and these was same then i created ecc writed ecc i have bridged 3 port on the proto board but it dosnt attempt to glitch why ?
Mobo Trinity
J r programmer V2
Slim proto
 
Utmad

Utmad

VIP Member
Aug 15, 2010
3,304
118
Southampton, UK
cod3mwf said:
I just installed my slim proto and my J r runner readed 2 nand dumps and these was same then i created ecc writed ecc i have bridged 3 port on the proto board but it dosnt attempt to glitch why ?
Mobo Trinity
J r programmer V2
Slim proto
Click to expand...
You need to fill in the template below, how can people help you from 4 lines of text !!

TEMPLATE
 
C

cod3mwf

Full Member
Dec 16, 2013
36
0
TX Product's used J-R programmer v2, Slim proto v1
Console Type Trinity
Dasboard version 2.0.16537
CB Version 9231
Jrunner.png
 
Antalpromille

Antalpromille

VIP Member
Aug 4, 2011
3,146
0
Borås, sweden
cod3mwf said:
I just installed my slim proto and my J r runner readed 2 nand dumps and these was same then i created ecc writed ecc i have bridged 3 port on the proto board but it dosnt attempt to glitch why ?
Mobo Trinity
J r programmer V2
Slim proto
Click to expand...
Re-read the install instructions, if you are following that it will work. And as others say, we need to see your work to tell what the problem is.
 
Oggy

Oggy

Staff member
Troll Eating Dogs
Mar 1, 2010
3,346
128




 
Oggy

Oggy

Staff member
Troll Eating Dogs
Mar 1, 2010
3,346
128
E/F are the wrong way around and postout looks like something I'd puke up on a Saturday morning.
 
C

cod3mwf

Full Member
Dec 16, 2013
36
0
Oggy E/f are in right spot , now i connected post_out to the alternative point but still no attemt to glitch
 
Oggy

Oggy

Staff member
Troll Eating Dogs
Mar 1, 2010
3,346
128
Now I wonder why my installs work and yours don't ?!?
 
  • Like
Reactions: xzanox
Antalpromille

Antalpromille

VIP Member
Aug 4, 2011
3,146
0
Borås, sweden
Look like theres a solderbridge on the bottom side, but your pictures are not that good and its hard to see anything wrong. You need to clean up your install, shorten the exposed part of the wires and post better pictures.

EDIT: and oggy is right, your E and F is in the wrong spot. I would start all over and clean that sh*t up.
 
Last edited:
C

cod3mwf

Full Member
Dec 16, 2013
36
0
what do u mean about wrong spot ? cuz i connected my E / F as the install / tuning guide says .
 
You must log in or register to reply here.