RGH Slim reading nand with nand x 2 bad blocks.

[mechgamer123]

Ok so far I've read the nand 3 times and I get the same 2 errors every time:
Error 250 reading block 271
Error 204 reading block 2EE
I've tried to re read these points with xnandhealer gui and it errors out every time. Should I get a donor Trinity nand and inject the blocks from it into this image? Xnandhealer GUI says that 271 is a necessary block. And if I do need a donor nand, does anyone know where I can get one?

Ok I have another quick question: Is there a quick way to remove the QSBs? I've been trying with desoldering braid and I can't budge it off.

 

[WestCoastConsoles]

You need to remap the bad blocks to the end of the NAND. There is an awesome tutorial on here.

 

[manwithoutname]

Only remap HHS blocks if what you intend to do first doesn't work. Example if you are creating a freeboot image for the RGH and it doesn't work then remap the blocks on the created image and re-write the image to your NAND.

 

[mechgamer123]

Only remap HHS blocks if what you intend to do first doesn't work. Example if you are creating a freeboot image for the RGH and it doesn't work then remap the blocks on the created image and re-write the image to your NAND.

You need to remap the bad blocks to the end of the NAND. There is an awesome tutorial on here.

Thanks for the quick responses! I've got another quick question that I posted in the OP: Is there a technique for removing the QSBs quickly? I can't seem to get this slim QSB to budge.

 

[WestCoastConsoles]

Desoldering braid and a little screw driver to lift the edge.