ANSWERED Slim RGH 0003 error

[apangilinan21]

pick this up for cheap thinking i can maybe play around with it and try to finish up the RGH job the previous person did.

its got the 0003 error code.

heres the pic of what "i think" is causing it.. maybe ? no?

from the looks of it , the resistor is gone. Isnt that a MUST to have?.

..

The Guy told me he was able to Finish up the Glitch Process and Assembled everything then thats when the "0003" error code showed up..

he sent me ALL the Backed-Up Files for the Glitch.

Any thoughts?

 

[hodgie]

There is supposed to be a 33ohm resistor in there. I'm not sure if that would cause the 0003. Bit I'm sure it doesn't help.

 

[DanTechMods]

I would put a 33ohm resistor in and clean up all the cut traces along its path. That error code can mean power issue or dead gpu.

 

[sick360mods]

to much wire and u need a 33 ohm there. i can do it for u for cheap. pm me if your interested

 

[paul.86]

too much wire and on end looks a cold solder joint (not hana side) make wire as small as poss scratch closer to damage join there and use a 33 ohh

 

[cskalash]

Actually you don't any resistor in there. Yes there was a 33 ohm resistor there, but that's not your problem. If that trace has any problem the console won't boot at all.
Your problem will most likely be the mosfets.

 

[cantwin]

It wouldnt hurt to clean it up and resolder it again.