Slim Trinity - Not Glitching

[willstrz]

Hi, its me again lol.
So, its showing the green debug light, but it is not booting to Xell. The dip switch is set to 3 and 4 up and all the rest down, and postbit is set to default. I have tried the post bit on 100, 10, and defualt. I have also tried just 3 up on the dip switch and all the rest down, with the postbit set to 100, 10, 0...

Is there anything is I can try?
(I have a PHAT Jasper here too, could try the R-TAG method on it)

Programmer Used: JRP 2.0
NAND size: 16mb
Console: Trinity
Was the console working before you started: YES
Do you get a green debug light appear on the CR4 XL chip every 4-5 seconds: YES

 

[scott1503]

pictures will be a great help

 

[willstrz]

pictures will be a great help

hi scott. i just tried to get some pictures, and i screwed the point POST_OUT. it was weak, and i tried to move it a little to get a good picture of it, but it broke lol. alernative? thanks lol

 

[nofeloniesyet]

hi scott. i just tried to get some pictures, and i screwed the point POST_OUT. it was weak, and i tried to move it a little to get a good picture of it, but it broke lol. alernative? thanks lol

so im assuming breaking the post point jus screwed the ability to post pics of the install? love how people will fill the template in alllll except for pics. pics are required,end of!

 

[Nadles]

hi scott. i just tried to get some pictures, and i screwed the point POST_OUT. it was weak, and i tried to move it a little to get a good picture of it, but it broke lol. alernative? thanks lol

Alt point is the exact other side of the board in that spot. Under the heatsink. Fix that then take pictures if needed still.

 

[willstrz]

Alt point is the exact other side of the board in that spot. Under the heatsink. Fix that then take pictures if needed still.

is the point that you are talking about a trace? Or is it like a actual spot?

 

[GeekHeat]

This Is The Alternative Point For it, Just Gentle Scratch The Point Apply Flux And Little Solder

Or u can use a postfix adapter.

 

[Nadles]

is the point that you are talking about a trace? Or is it like a actual spot?

Trace. That's all you got. Figured that would be obvious. Since it's the only thing on the exact other side of the board in that exact location. GeekHeat gave Picture. Be smart with this one. Like I said, that's all you got.