ANSWERED Slim-Un-Lock command returned an error

[Deleted TX Member]

I wrote it before -

I tried the 100 ohm method, it worked.

 

[DUSTYB3N]

So have you managed to sort the issue?

 

[Deleted TX Member]

Not really.
As I said, clicking the "Read" returns an "Invalid Status 0x0" message on the log, nothing else.
same thing with "Write"

I tried to outro the drive and then intro, and then writing worked, tho after writing I got this on the log:

Getting Status from port 0x0000

SPi flash found with Status 0x72



Sending Chip Erase to Port 0x0000

Erasing:

Writing target buffer to flash

Writing Bank 0: ................

Writing Bank 1: ................

Writing Bank 2: ................

Writing Bank 3: ................

............

Flash Verification Test !

Reading Bank 0: ................

Reading Bank 1: ................

Reading Bank 2: ................

Reading Bank 3: ................

Dumped in 3894mS



Write Verify Failed !

So I'm not even sure I flashed correctly.
I then tried to lock the drive, and again -

Sending Spi Lock request to Port 0x0000
Lock Failed !
Spi Status: 0x00

So I did outro and intro again, and the locking worked.
So basically I have to outro and then intro before using any of the "Read/Write/Lock" buttons.
And again - the write failed to verify so idk if it flashed correctly.

 

[DUSTYB3N]

Are you following the jungle flasher tutorial exactly?
http://hotfile.com/dl/129074413/6f8714b/jftut1.4.4.rar.html Available here follow this step by step and you shouldn't go wrong!

 

[Deleted TX Member]

Yes, I've followed the tutorial exactly..
But there's a couple of things I find weird:
1. The tutorial says that after clicking the spi status button, this message should pop up:

Spi Status is S/W protected

But when I click it this message pops up:

Spi Status is H/W protected

2. The tutorial says:

At the point that Jungleflasher is able to successfully unlock the drive – a “DUAL-TONE BEEP” will be heard through your speakers

I heard 3 beeps.

Idk, maybe that means something..