RGH Slim wont boot xell

W

WNYConsoles

Troll Eating Dogs
May 21, 2010
2,195
128
Blackwater, Great Plains
team-xecuter.com
What have you done as far as your RST wire? Are you use the POST QSB? If you can, please post pictures of your entire installation.

I have found that on Slims if your RST line is to short or to long it won't glitch at all, you may get one debug light (green LED) and after that nothing.
 
X

xboxnick360

Full Member
Nov 8, 2011
65
6
one moment

---------- Post added at 22:56 ---------- Previous post was at 22:49 ----------

im trying to take pictures now any suggestions in the meantime
 
X

xboxnick360

Full Member
Nov 8, 2011
65
6
the pictures just arnt clear n i find 30 gauge wire works best why dont u provide sum advice or keep off the thread

---------- Post added at 23:31 ---------- Previous post was at 23:27 ----------

changed the length of the rst line to 50cm n still not glitching help please
 
X

xboxnick360

Full Member
Nov 8, 2011
65
6
i dont have a good camera any ideas of what it culd b im trying alternate points right now see if anything changes
 
X

xboxnick360

Full Member
Nov 8, 2011
65
6
yes i have tried both im in the middle of using alt points right now to see if that has an effect

---------- Post added 22nd February 12 at 00:02 ---------- Previous post was 21st February 12 at 23:56 ----------

still not booting wth :(
 
reefz3ro

reefz3ro

VIP Member
May 30, 2011
669
0
Pittsburgh, PA
i would suggest cutting all the wires the same lenghts that come with coolrunner but aside from that your CPU_RST wire looks like its routed in a bad place...if i were you i would take the CPU_RST threw the large hole in your pic and wrap it up under the xclamp and see if it will boot to xell
 
X

xboxnick360

Full Member
Nov 8, 2011
65
6
FIXED!!! finally booted using alternate points for clk and post out then also wrapped the rst wire around the x-clamp
 
You must log in or register to reply here.