So I thought I bricked my Lite-On...

[tempora97]

During the process of upgrading from 1.91 to 2.0, after erasing and during the process of writting..Seemed to be taking a bit (over 30 seconds) to get past first line "results". so I looked over and my 360 was off. Turned it back on and JF wouldn't see it. Rebooted PC, JF saw it and it was in Vendor mode...ok, no worries..just erase it again and try to write....negative due to "unknown" version (if i recall correctly). Ok, try to reboot pc/JF again and I noticed no activity on lite-on drive and flashing green on my 360. Did some research and found lite-on can't be bricked. so I found the video to use iXtreme 1.5 and iPrep .62. This is where my night was about to causae me to break out the Jack and Coke. Was not able to load ANY iXtreme firmware. Nor could I run JF 1.5 due to PortIO error.

Any suggestions and/or what the hell am i missing......!?! Trying to flash via DOS at this point to save the lite-on drive but nothing seems to be working for me tonight

Thanks :sigh:

 

[ReMix]

use the latest JF

intro/device id (or lite-on erase) to the port you use for flashing, yes i know your drive won't show up
press yes
power cycle your drive

 

[tempora97]

Loaded Dummy
Loaded latest FW

Lite-On Erase

Drive returned status 0x0
....................................
Device Intro failed!


No longer in vendor mode by the way.

 

[tempora97]

apparently a good night sleep and persistence pays off. I think I was just looking at it too much last night. currently sitting on 2.0

 

[macintyre2000]

During the process of upgrading from 1.91 to 2.0, after erasing and during the process of writting..Seemed to be taking a bit (over 30 seconds) to get past first line "results". so I looked over and my 360 was off. Turned it back on and JF wouldn't see it. Rebooted PC, JF saw it and it was in Vendor mode...ok, no worries..just erase it again and try to write....negative due to "unknown" version (if i recall correctly). Ok, try to reboot pc/JF again and I noticed no activity on lite-on drive and flashing green on my 360. Did some research and found lite-on can't be bricked. so I found the video to use iXtreme 1.5 and iPrep .62. This is where my night was about to causae me to break out the Jack and Coke. Was not able to load ANY iXtreme firmware. Nor could I run JF 1.5 due to PortIO error.

Any suggestions and/or what the hell am i missing......!?! Trying to flash via DOS at this point to save the lite-on drive but nothing seems to be working for me tonight

Thanks :sigh:

you cant brick lite-ons.