soldering questions

[NumbNess]

i would like to know what soldering kit i should buy and the tip size and solder size for bridging the r2c6 and r2c7.
would this be ok ? http://www.amazon.com/Aoyue-Variabl...indust_10?ie=UTF8&refRID=0A43PCDK2GPF2MSY4R51


thanks

 

[RayBray]

Hi buddy.

This is a simple question, any one with even basic soldering skills would know what they would need.

I guessing you have just started to solder recently and which i would recommend using a 18w soldering iron with 1/2 millimetre solder use a flax but not to much. Also did I mention that you need to practice practice and practice.

 

[NumbNess]

ok thank you.
could you tell me the tip size you recommend for bridging those extremely small points? r2c7

 

[BL4K3Y]

ok thank you.
could you tell me the tip size you recommend for bridging those extremely small points? r2c7

I use a 1MM conical soldering iron tip for all my soldering work.

If you plan to install any DemoNs, use some thin solder - I prefer to use 0.7MM.

 

[Ac1dR3d]

im using - Solder Iron Tips 900M-T-I Silver - wich im verry happy with
think my iron wire is 0.5/0.7 mm
and my soldering iron is solder-sp60 12v 60 watt
i use some fency german soldering flux - Lotfett <3

 

[NumbNess]

i am researching soldering a lot before i even try RGH2 and most people are saying about 600F is what i should have it set to for surface mount component like wires and qsb.
is this about the same you all use? don't want to damage anything so wanted to double check with you.