Solderless Install - Xecuter 2.6CE

[DForbes]

OK,

I got my Xecuter 2.6CE and I have read through the threads here. I got as ton of stuff with my chip and I am not sure if I need it all since I think I have a version 1.1 XBOX. Do I still need to solder the green, red, and grey wire on the back side of the motherboard? I got a bunch of little hollow tubes with the wireless adapter...are these used with the grey, green, red wire adapter somehow?

Thanks in advance.

Darren

 

[DForbes]

Help!!!

Is this thread not worthy or something. Could someone at least point me in the right direction.

Darren

 

[Rookio]

G'day, The Little Pins you got are supposed to go into the LPC holes before you put your xapter on.

The Red/Green/Grey wires are not required in a solderless install.

 

[DForbes]

Thanks alot for the reply.

Another question:

Which Bank do I set the module to? I have an xbox version 1, so set to bank one?

Thanks

 

[Rookio]

I believe bank 1 or 2 will work in your case. Make sure of this by turning it on with bank 1 set. then turning it on with bank 2 set.

If only 1 works, use that one, BUT change the switch before flashing, so you keep a backup for Justin.

 

[DForbes]

Still No lUck

I tried both bank one and bank two and neither will work. I guess I will have to flash the bios however that works. I assume I have to have flash protection off to do that. Man I hope I don't have a dead chip.


Darren