Solid green center light on RF module after writing ggbuild image

[oic989]

I'm not sure what to do with this symptom.

I built the nand image with multibuilder, and that all went fine. After flashing that image to the 360, if I have the dvd drive plugged in, the center light stays solid green. Without the dvd drive connected, it flashes normally and the one time the glitch worked (jasper without a capacitor yet) it stuck partway through the swirling boot animation.

The read/write of the nand has been without error. All my clean dumps compare fine. If I write the stock clean image back, it boots and operates fine.


I'm dumping it with nandpro -r64 (file)
and writing it with nandpro -w64 nandflash.bin
on a 256meg jasper with a 13604 dash.

The flash config detects properly.

I'm not sure what to check or do differently. Everything seems to be working exactly as it should for the read/write/build processes.

Any ideas?

 

[stred]

After flashing that image to the 360, if I have the dvd drive plugged in, the center light stays solid green. Without the dvd drive connected, it flashes normally

thats normal behavior for a 360

 

[oic989]

OMG, WAT?

Now I feel like a big dummy. I thought the center light blinked until it posted.

I just tested it on my all stock box and see that you're correct. Thanks for pointing out the obvious.

I guess I was too prepared for it to fail because I had a lot of trouble getting it to this point.

Carry on.

 

[Akilles]

thats normal behavior for a 360

LMAO good one!

 

[oic989]

I just left it glitching with the drive in, and it eventually came up. Took about 2 minutes.

I'm annoyed with how stupid of a mistake that was. :facepalm:

So I guess once my caps get here in the mail I'll be all set. Yay.

Thanks again!