some questions about jasper and glitch

[x23are]

i have a question.
i got 3 jaspers and glitch them.
i saw different result beetween them.(the installation is exactly same even wires length).
first: jasper 512: 68nf cap bridge.(whitout cap long boot time)
it boot whit one blink and 4sec but sometimes CR blink first time and finish blinking after it but console dont boot.

second: jasper 512: 68nf cap dont bridge.
it boot whit one blink or two every time and dont have above problem.

third: jasper 16: 68nf cap bridge.(whitout cap long boot time).
it boot whit one blink and 4s but sometimes it boot whit 4-7 blinking(15-27sec).

cpu_rst wire place is top of the board and near fans.
my question is:
Do you have this problem on jaspers and is this usual?
thanks my dears.

 

[studiovpc]

yup pretty usual with jaspers, worst for glitching are those from 06/2009, big block 512 mb, you have to do miracles for it to work properly, and once you manage to boot consistently around 5-10 secs depends every time, you have to pray to god that you won't have any freezeing in games...

 

[riget]

I had the same as with your first, I don't think they have the answer

 

[WNYConsoles]

If you have bad boot times with Jasper WITH CAP bridged try 68nF on ground/pll and if that doesn't help add an additional 68nF in-line RST.

Some will say in-line RST cap is no good however I have done dozens this way when the CR was first released and have seen no negative effects, only positive effects with boot times