Some questions

[SimbAA]

If i buy a DemoN,should i rgh my 360,or a DemoN is already a RGH'd nand?Is RGH 2.0 working on dash 16747(i think yes but im not sure)?Can i rgh my falcon only using a Coolrunner Rev C and a J-R Programmer?Thanks.(sorry if my english is bad, im french)

 

[SimbAA]

Oh,im sorry, i didn't saw it.Thanks you, it respond to all of my questions,except this new : What the differences between RGH 2.0 and R-JTAG ?What have more functions ? What is the chipest ?

 

[Taijigamer2]

Both are different methods for glitching the console to allow homebrew code to run on the 360. Both cost about the same.

http://team-xecuter.com/forums/showthread.php?t=78885

http://team-xecuter.com/forums/showthread.php?t=135779

http://team-xecuter.com/forums/showthread.php?t=139308

http://team-xecuter.com/forums/showthread.php?t=82434

Enjoy.

 

[SimbAA]

Thanks you ! Just a last question : if i have a DemoN,a CR Rev C and a J-R Programmer, is it not a problem that i use J-R P to program the CR ?(cuz i heard that a DemoN can replace a nand reader)

 

[Taijigamer2]

Use either or. Both are capable of reading/writing the nand. The Jrp communicates through SPI while the DemoN communicates directly with the Nand chip. If u are going to install a DemoN for dual nand, it makes sense to read/write nand with that. Use your Jrp for programming the Coolrunner through jtag.

 

[SimbAA]

Thanks you very much :biggrin: so i need to install demon first right ? Can you send me a tutorial that show how to read/write with a DemoN ?

 

[SimbAA]

All my thanks goes to you guys :wink:

 

[nofeloniesyet]

demon can also program the coolrunner,so no need for a jr programmer