Sonus 360 Phat

[BornToDie423]

I have searched and searched.. And searched, but I can't manage to find a guide for the wiring of a Sonus 360 Phat if you have clipped the Nand-X/JRP QSB Cable.

I would prefer to get it done now without have to wait for a new cable to come in the mail, I'm just not sure where to solder the wires directly to program the Sonus 360.

As per every question, I'm sorry if this comes up a lot, but, as stated, I can't manage to find it.

Anything that helps would be greatly appreciated!!! Thanks.

 

[chase]

the pic below shows you how to solder if you've clipped off the qsb connectors.. you just have to figure out which wire to which pin based on connector orientation

 

[BornToDie423]

If I am not mistaken, the White three pin connection, starting from the side with J3 and White(Closest to the corner), is red, orange, yellow.

The blue two pin, starting closest to J1( again closest to the corner), is brown then black.

Then the green two pin starting closest to the word green would be: blue then green.

Would anyone care to confirm?

I have included a picture that may help with visualization.

 

[chase]

the green connector is wrong .. check the picture below

 

[gavin_darkglide]

Just buy another nandx cable, less likely to ruin a $20 piece of hardware.