Sonus & ROL

[Suggy47]

Hi all, I have connected the wire from the Sonus QSB to the ROL on the CR4.
I get the Glitch sound when starting up when booting from the Demon and no start up sound. Eject as it should be but when I boot from the retail nand I still get the same results as when booting from the Demon.
I have put a multimeter on the ROL and its 3.3v on both the retail and Demon nand.
Iam gessing I should only get 3.3v when the Demon is active?

Does the wire to the qsb only be 3.3v when booting from the Demon for it to work correctly? If so is there an alternative point on the CR4 for 3.3v?

 

[Antalpromille]

The ROL pad on CR4 differs from the older versions of CR from Xecuter, this one pulls low when it should blink but the older ones pulls it high when it's supposed to blink.

Try soldering it to the secondary side of R40 instead of the ROL pad.

 

[Suggy47]

Thanks, will have a look after work

 

[Suggy47]

Ok tried that and booting Demon I get start up followed by glitched and booting from retail I get the same but with a 1sec gap inbetween

 

[Antalpromille]

It's probably because CR4 actually sends one blink even on retail, at least mine does.

 

[Suggy47]

Is there any where on the Demon I can use? or do I have to put up with it?

 

[Suggy47]

I take it's there's nothing on the Demon! Just want to know before I put the console back together

 

[Suggy47]

Tested every point on the CR4 and I still get the same results, so I guess I would have to add a relay for this to work. I already have 2 relays fitted (HDD power & Sata) so would the CR_EN point on the Demon be able to run a 3rd relay?