Hey guys, what's up? I'm new to the forum but old to the whole Xbox 360 flashing thing. So let me relate what happened with a customer X360 last evening:
Sending Device ID request to port 0x0000
Spi Status: 0x8C
Manufacturer ID: 0xEF
Device ID: 0x11
Flash Name: Winbond/NEX(W25P20/NX25P20)
Flash Size: 262144 bytes
Sending Spi UnLock request to Port 0x0000
.......................................................................................................................................................................................
Spi Status: 0x00
Getting Status from port 0x0000
Serial flash found with Status 0x72
Reading Drive Key.
............
Authorised !
Grabbing sector 0x3E000.
................
Blank 3E000 sector detected!
Known f/w confirmed !
Sending Vendor Intro to port 0x0000
Status 0x51
Re-sending Vendor Intro:
..................
Serial flash found with Status 0x72
Sending Device ID request to port 0x0000
Manufacturer ID: 0xEF
Device ID: 0x11
Flash Name: Winbond/NEX(W25P20/NX25P20)
Flash Size: 262144 bytes
Updating flash for on-line dump.
Sending Sector Erase to Port 0x0000
By there nothing else happens... After trying to get the thing done a whole bunch of times I started noticing that the SPI status after the freeze stays at 0x3c or 0x3e and the the 0x8c/0x00 box stays blank, just like that:
Sending Device ID request to port 0x0000
Spi Status: 0x3C
Manufacturer ID: 0xEF
Device ID: 0x11
Flash Name: Winbond/NEX(W25P20/NX25P20)
Flash Size: 262144 bytes
OR
Sending Device ID request to port 0x0000
Spi Status: 0x3E
Manufacturer ID: 0xEF
Device ID: 0x11
Flash Name: Winbond/NEX(W25P20/NX25P20)
Flash Size: 262144 bytes
The only way out was CTRL+SHIFT+F11, what takes me back to 0x8c and it starts over and over...
What should I do? What did I made wrong?
Obs.: I was almost forgetting, the drive stays playing very well, DVDs and originals
