FIXED SPI status is 0x8C?

[crazy-gamer]

ok, well i am trying to flash my slim and instead of getting "0x00" i get 0x8C

how can i fix this? my key is verified though

 

[x360ccm]

jf log would help...and how you trying to unlock the pcb.

 

[doe1200]

you need to unlock your pcb is it a mxic or winbond

 

[crazy-gamer]

im pretty sure i unlocked it


i have an MXIC and im using the sputnik probe (no solder)

 

[doe1200]

try a different resistor setting on the probe,also have you cut the trace

 

[x360ccm]

10 ohms always works for me.

 

[crazy-gamer]

how do i know if i unlocked it right?

---------- Post added at 17:26 ---------- Previous post was at 17:25 ----------

10 ohms always works for me.

how do i get 10 ohms i am a noob to this

 

[doe1200]

jungleflasher will beep,push second switch up on probe 10ohms,1 3 and 4 down,look here SPUTNIK360 SWITCH & PROBE - Instructions

 

[crazy-gamer]

jungleflasher will beep,push second switch up on probe 10ohms,1 3 and 4 down

i didnt get a beep


i cut the trace and im probing the spot but its not working:\

 

[doe1200]

when you intro the drive did you click the radio button were it says 0x8c to start the unlock.

 

[n1ght0wl]

did you even read this >> http://www.team-xecuter.com/forums/showthread.php?t=72098

 

[crazy-gamer]

still nothing, im doing everything right

am i supposed to cut while the power is on?

 

[doe1200]

no,try a different resistor setting on the probe SPUTNIK360 SWITCH & PROBE - Instructions

 

[crazy-gamer]

did you even read this >> http://www.team-xecuter.com/forums/showthread.php?t=72098

yes, i did ive read it quite a few times. i cut where im supposed to cut and its not working for me.

 

[J2G]

take a close up pic and post it here so we can rule out the install...

 

[crazy-gamer]

when you intro the drive did you click the radio button were it says 0x8c to start the unlock.

no, i didnt see any of that in the tutorial it just said cut in one spot, then probe then go to jungleflasher,
and power cycle and hit unlock when the option comes

 

[doe1200]

intro your drive power cycle,push the radio button were it says 0x8c its just under write you will get a message,click yes dots will start,probe the hole and wait for the beep.

 

[crazy-gamer]

yes! thank you so much! i heard the beeps!

thank you so much! i appreciate your help so much!

---------- Post added at 18:03 ---------- Previous post was at 18:02 ----------

post is done, can set to fixed now

 

[x360ccm]

how do i know if i unlocked it right?

---------- Post added at 17:26 ---------- Previous post was at 17:25 ----------



how do i get 10 ohms i am a noob to this

you 4 dip switches on the probe same as the switch, second one is the 10 ohms..

:rolleyes2: