SPI status not active!!

Argentum

VIP Member
Dec 13, 2011
388
0
Khobar, Saudi Arabia
I got a pcb from a Liteon 16D4S fw 401 with winbond IC that was unlocked by Germias unlock.

I am using jungle flasher 1.90 with X360 USB pro and CK3i. I pcb was detected and I got slim key and saved the dummy.

The issue is when I go into vendor mode, although it showed good flash properties (but spi status 0x0c), however, the spi status button is not active so I am unable to send lock or unlock commands!!

Any Ideas?

an image is in the attch.
 
Last edited:

doe1200

VIP Member
Feb 21, 2011
460
48
northern ireland
i see your spi status is 0x0c try rubbing a bit of alcohol on a q tip in the drilled hole are shut jungleflasher down and try and intro it
 
Last edited:

Argentum

VIP Member
Dec 13, 2011
388
0
Khobar, Saudi Arabia
It did not work ... although the sequence seemed strange

rub alcohol close JF, open and intro
 

Argentum

VIP Member
Dec 13, 2011
388
0
Khobar, Saudi Arabia
Thx man worked perfectly