I'm trying to install the new 2.0 Firmware on a spoofed Samsung, but when I'm trying to put in vendor mode with Sammy unlock, I'm putting on B mode and it says failed, and when I try with intro/device ID, it starts on 0x80 but when I turn off and turn on back, it says 0x90!!! I don't know what to do!! please!!
GENERAL Spoofed Samsung (lite on) can't get vendor mode to install 2.0fw!!!! please!!!
- Thread starter allanisok
- Start date
Martin C
VIP Member
Either read the guide how to flash a samsung drive or get someone to read it for you!
knowlzy10
BANNED
knowlzy10
BANNED
firstly mode b is for hitachi drives, secondly as frazzeld just said have you read the jungleflasher tut properly, and last but not least you not stated what tools your using to attempt this, im guessing the ck3 is in there somewhere for mode b
When i put tray half open with JF, in sammy unlock, it says failed, and intro/device id won't work, if somebody has a guide that can send me, i will apreciate! remember it's a spoofed samsung.
knowlzy10
BANNED
good point cause if its the liteon spoofed you will need phat key extract not sammy unlockso is it a liteon drive with sammy fw or the other way round?
dale
I've always found that the activate iso unlocks a stubborn samsung....download and burn to DL-DVD
i intro device ID and turn on and off a few times....i get it to work most of the time doing this
Half open or full open?
---------- Post added at 15:09 ---------- Previous post was at 15:07 ----------
I will try with activate iso! thanks!!
---------- Post added at 15:14 ---------- Previous post was at 15:09 ----------
Wich version of Activate iso do i need?
---------- Post added at 15:09 ---------- Previous post was at 15:07 ----------
I will try with activate iso! thanks!!
---------- Post added at 15:14 ---------- Previous post was at 15:09 ----------
Wich version of Activate iso do i need?