Console Type: Falcon
NAND size: 16
Dashboard version: 2.0.16537
CB version: 6774
Screenshot of NAND details from J-Runner:
J-Runner log: No log
POST output from J-Runner (either POST_OUT monitor or RATER output):
(2 cycles is enough)
updflash.bin log (if applicable): No
Image of R-JTAG board: No, desoldered
Images of close-up soldering to motherboard: Yes
Was the console working before you started: Y
Kind of installation: Wired installation
Description of problem:
Stock nand gives Rrod at intro screen
Hi,
Got a situation here. Yesterday I wanted to R-Jtag a Falcon. I followed the next steps;
1: Read nand – OK
2: Ticked R-Jtag – Audio clamps
3: Create Xell and write to nand
After this I connected the Qsb post and Jtag Alt V2, wires and was ready to go. When I started up to get Xell default at switch 7 for a falcon I get on everything switch 2 red rings. Also tried 1.2v and other voltages with the same result.
At the end I desoldered everything and wrote back my original nand, when booting in stock I get the same 2 red rings of death.
After 5 seconds the intro appears and after this directly I get the 2 rings.
Ofcourse I checked all solder points for shorts, cleaned up at all solder point but still no result after booting up again.
I included pictures of J-Runner and all solder points, help would be appreciated.
NAND size: 16
Dashboard version: 2.0.16537
CB version: 6774
Screenshot of NAND details from J-Runner:
J-Runner log: No log
POST output from J-Runner (either POST_OUT monitor or RATER output):
(2 cycles is enough)
updflash.bin log (if applicable): No
Image of R-JTAG board: No, desoldered
Images of close-up soldering to motherboard: Yes
Was the console working before you started: Y
Kind of installation: Wired installation
Description of problem:
Stock nand gives Rrod at intro screen
Hi,
Got a situation here. Yesterday I wanted to R-Jtag a Falcon. I followed the next steps;
1: Read nand – OK
2: Ticked R-Jtag – Audio clamps
3: Create Xell and write to nand
After this I connected the Qsb post and Jtag Alt V2, wires and was ready to go. When I started up to get Xell default at switch 7 for a falcon I get on everything switch 2 red rings. Also tried 1.2v and other voltages with the same result.
At the end I desoldered everything and wrote back my original nand, when booting in stock I get the same 2 red rings of death.
After 5 seconds the intro appears and after this directly I get the 2 rings.
Ofcourse I checked all solder points for shorts, cleaned up at all solder point but still no result after booting up again.
I included pictures of J-Runner and all solder points, help would be appreciated.
