RGH Stops reading nand with nandx.

L

Lucky257

Junior Member
Feb 27, 2012
22
0
Hello, I am running into a problem with my nandx. I once got it to read the nand off of my xbox. I then got 2 successful reads. Later I tried again and it then said "Can not continue." I next tried to reboot everything and now it will show up with (Trinity Arm Version: 3) then nothing. I try it again it says "Can not continue." When I reboot it same thing as at first. I think it is like software or something because I have re soldered this like 5 times. Any help would be nice. Thanks.

---------- Post added at 22:05 ---------- Previous post was at 22:03 ----------

Another thing I was using Jrunner. I tried other programs but they wouldnt even get to Trinity
Arm Version: 3.
 
oO Elite Oo

oO Elite Oo

VIP Member
Sep 3, 2011
1,837
0
In your Nand
Install the drivers correctly for NandX then use J-Runner from their, make sure your wires are correct and their are no bridges. Other wise post picture of your connections for NandX.
 
  • Like
Reactions: Lucky257
L

Lucky257

Junior Member
Feb 27, 2012
22
0
Ok I will post pics tomorrow. With the drivers shouldn't they be the same if it worked before. Thanks.
 
L

Lucky257

Junior Member
Feb 27, 2012
22
0
oO Elite Oo said:
If you used nandx on same pc with driver already installed then no need to install again.
Click to expand...
Yeah, it is the same pc. The thing is jrunner says what motherboard it is and then nothing. It does detect the nandx and the nand so this confuses me. I will post pics though tomorrow.

---------- Post added at 00:37 ---------- Previous post was at 00:35 ----------

I just tried it again with Jtag tool. It worked with that. So now why won't it work with jrunner? Owell just a bug then it is in beta.
 
B

BoSsLoBbYz

Full Member
Jan 21, 2012
28
0
I have had some problems like this too I have found that if you disconnect the hana point it will read and write again like normal
 
You must log in or register to reply here.