hey . i rgh my console nw . an it works perfectly but when shutdown it . the console shutdown but the remote controller not. and console work again by itself
strange problem
- Thread starter AnasMostafa
- Start date
Martin C
VIP Member
You mean the controller is still flashing and it syncs up with the console again, causing it to start?
yess
---------- Post added at 20:00 ---------- Previous post was at 19:53 ----------
so when i need to shutdown it . i must take battery off from controller and shutdown it
---------- Post added at 20:00 ---------- Previous post was at 19:53 ----------
so when i need to shutdown it . i must take battery off from controller and shutdown it
Martin C
VIP Member
So possibly something you've done on the RGH side of things, especially if the RoL board isn't turning off the controller.
Pics of your install please.
Pics of your install please.
http://desmond.imageshack.us/Himg822/scaled.php?server=822&filename=p1010004fe.jpg&res=mediumlinks removed.
Last edited by a moderator:
Martin C
VIP Member
1. Route the cable EXACTLY as shown in the tutorials.
2. If you're going to post pics, don't waste people's time with blurry crap. There's no point in you doing this. If you don't have a camera, borrow one. If you don't know how to use the camera, get someone to help you.
2. If you're going to post pics, don't waste people's time with blurry crap. There's no point in you doing this. If you don't have a camera, borrow one. If you don't know how to use the camera, get someone to help you.
Have you even tried to route the wires in the way that the tutorials describe?
Then when it didn't work did you change it to this route?
Or did you just use this route from the start, and wonder why your box is acting strange?
Tutorials are here for a reason you know.
Then when it didn't work did you change it to this route?
Or did you just use this route from the start, and wonder why your box is acting strange?
Tutorials are here for a reason you know.
Martin C
VIP Member
Flash the original NAND back and see if it still does it. No need to remove anything, it should work.
If you're still having the same issues, either something is bridged or you've knocked something during the soldering.
If you're still having the same issues, either something is bridged or you've knocked something during the soldering.
Martin C
VIP Member
Are you 100% sure it wasn't doing this before you did the RGH?i flashed the original NAND back . and same problem
If so, you need to work backwards and remove the wiring from the motherboard completely.
Failing that, posting GOOD QUALITY pics might help identify where you've messed up.
PS - don't send me a PM asking if I know how to fix it. You messed it up and I have no idea what you've already done.