Hey
Trying to RGH a Jasper 16MB BB
Soldering seemed fine, dumping gave error 250 @ 0x370 in all dumps so I went with it.
After flashing ecc it wouldnt boot xell (just kept rebooting/glitching) so I soldered the CAP and it instantly booted into xell so I got cpu key etc.
Using the key I made my bin, put xenon.elf and nandflash.bin on a fat32 usb (as I've done on the other two boxes I've glitched) and it started flashing but it stuck at "processing block 0x015e of 0x0400"
Last time I flashed my hdmi connection was kinda spooky so my screen looked strange but when I switched input back and forth on monitor I got a clean image saying it was fine but no such luck this time.
Can I turn of the xbox and try again or should I try flashing via jrunner?
Trying to RGH a Jasper 16MB BB
Soldering seemed fine, dumping gave error 250 @ 0x370 in all dumps so I went with it.
After flashing ecc it wouldnt boot xell (just kept rebooting/glitching) so I soldered the CAP and it instantly booted into xell so I got cpu key etc.
Using the key I made my bin, put xenon.elf and nandflash.bin on a fat32 usb (as I've done on the other two boxes I've glitched) and it started flashing but it stuck at "processing block 0x015e of 0x0400"
Last time I flashed my hdmi connection was kinda spooky so my screen looked strange but when I switched input back and forth on monitor I got a clean image saying it was fine but no such luck this time.
Can I turn of the xbox and try again or should I try flashing via jrunner?

