SW 4.0.1 and Micro SD cards
- Thread starter ArcXero18
- Start date
You need to update with exfat support marked.
I don't think I worded my issue properly. Apologies. My issue is that I'm unable to use a SDXC SD Card without prompting to update the system.
Format your SD card to fat32.
It'll then run on the switch, then do what was posted earlier then you can freely use an exfat formatted card
It'll then run on the switch, then do what was posted earlier then you can freely use an exfat formatted card
Do not update to 7.0/7.0.1 if you want to se SX CFW right now. Your issue is most likely that you SD card is formatted exFAT and you do not have the driver since the Switch does not support exFAT out of the box.
Follow the offline update guide to update to 6.2 and make sure to select exFAT.
Follow the offline update guide to update to 6.2 and make sure to select exFAT.
It's in this guide. Just follow it and you can just install the same FW that you are already running, but select the exFAT version. Before even doing that you can always format back to fat32 and make sure everything works. Just back up your license file and any other important files first.
@ArcXero18 forgot to add this part if you haven't done anything yet. Make sure to make a nand backup first.