Hi, I have 2 RGH Trinity's and want to return one of them back to stock so I can play on live. I heard all I have to do is restore the nand to its orginial stock nand, and remove power from the coolrunner. Is this true? Thanks!
RGH Switch Trinity back to stock
- Thread starter dx5512
- Start date
Martin C
VIP Member
Also I'm waiting for my nand-x to arrive so i can restore this box to stock and since i already have my soldering iron i was wondering is it ok if i remove the CR and its wires and then when the nand-x arrives just flash back to stock? Thanks!
Just use raw flash and change your nanddump orig to nandflash turn cr to org
Sent from my HTC Desire Z using Tapatalk
Sent from my HTC Desire Z using Tapatalk
No, you do not need your CPU Key for the stock nand. It's also best to leave the CR in there if you plan on using it later. Messing with solder points could cause damage if you are not experienced.
Ok, i already removed the cr and its wires (not using it on this console anymore) was very carefull, and all I have to do next is reflash the stock nand and thats it right? Thanks!
Martin C
VIP Member
Hey all, So I have been browsing sites and you tube and decided to try CR3 Lite in a Trinity. I'll be the first to admit I should have done some...ok, alot more research. Well any who to make a long story short, all went well until the "write ecc" function. The process was interrupted so needles to say the unit will no longer boot. At power up I get a steady green light for a while then a flashing one.I DE-soldered and uninstalled the CR3 Lite initially thought the issue was my install. After reading more I realized it was the Writing ECCs function that i messed up. So I m to understand with my 4 successful nand reads I can flash my nand back to stock. I am hoping someone can provide a tut or a how to. I am using J-runner and windows 7.
Martin C
VIP Member