I installed sxcore already, it's can work, and then I update system use choidujourNX. I close option auto RCM , after finish, sxcore is pink light, switch won't boot, help me please
Last edited:
switch v2 installed sxcore, help me please
- Thread starter zhaoran25
- Start date
If you're getting the pink light, it means the chip is having trouble communicating with the NAND, so I think you might have a bad solder joint. Please read the new released manual more info.
thanks a lot, but switch can work when I soldered, it's green light, but I finished update system, change pink light, won't boot, because I closed auto RCM option
the problem is that you shouldn't have updated with chou.... beta testers had sayd not to update with chou... and wait a solution for TX to upgrade.
You should have backed up your nand after installing your SX Core as I did with mine. Now you have to wait for a solutionI installed sxcore already, it's can work, and then I update system use choidujourNX. I close option auto RCM , after finish, sxcore is pink light, switch won't boot, help me please
You have to wait for the solution! Does your Switch boot to the bootloader or does it stay black and the light is pink on sx core?
did you like me ? update system use for choi and closed autoRCM option? or not close but had same problem?
How do you update the firmware without ChoiDujourNX? Waiting for SXLite and don't mind if console gets banned but then how would you update the OFW?
I am also in the same situation. The question is whether there is any way to repair it directly via USB PORT?
i have 2 switchs , v1 and v2 both,they still in pink light after i used exfat sdcrad boot...
i have 2 switchs , v1 and v2 both,they still in pink light after i used exfat sdcrad boot...
Last edited:
DAM!!!!
I made the same mistake....
SXCORE welding great (self pat in the back)
I get a green light, and i can run CFW SX3.0.2 , original NAND backuped.
i can run games from the SXOX menu.
N.Switch cant uses extFAT so i decided to update to update to 10.0.4 with CHOI
Now, i get a pink light and the N.Switch doesn't boot.
Is there a way using the SXCORE usb port to replace the Nand and Boot0/1?
I made the same mistake....
SXCORE welding great (self pat in the back)
I get a green light, and i can run CFW SX3.0.2 , original NAND backuped.
i can run games from the SXOX menu.
N.Switch cant uses extFAT so i decided to update to update to 10.0.4 with CHOI
Now, i get a pink light and the N.Switch doesn't boot.
Is there a way using the SXCORE usb port to replace the Nand and Boot0/1?
Did you have emunand? If yes, maybe you updated your emunand. Try to remove emunand and see if it boots to bootloader. If you did that update to your sysnand, than you have to wait for a solution.
In this care I did the update directly on sysnand. (I'm so stupid, I have to remember never touch the sysnand, I should be always playing around with the emunand )